Dynamics Payroll Inspector is a compliance tool that has several tracker options. Each of these trackers has its own setup and settings that need to be configured.

Advanced Settings within each tracker provide additional options that will also affect the results of the trackers you are using.

There are three categories of Advanced Settings.

• Inspection Frequency
• Inspection Filters
• Reset Information

Each tracker's Advanced Settings are specific to that tracker only; you will need to configure these additional settings for each tracker you are using.

Inspection Frequency

On this tab you can define whether or not you want this tracker to run automatically. If unchecked, you will select how often you want the tracker to run. If checked, the tracker will only run when you manually run it.

Inspection Filters

On this tab you can define which employees should be scanned. You can choose to scan active employees only or both active and inactive. If you need to run the tracker for a specific subset of employees you can temporarily update the setting to limit the employees by departments, work locations, classes, etc.

If you find that you are missing employees in your scans, this is the first section to check. Verify if the employee is active or inactive and that you don't have any filters that might be excluding them.

Reset Information

Lastly, this tab is used for troubleshooting or bring the tracker back to its original settings.

The system caches results, so that you are not scanning all employees at every interval, but only the employees with changes. If you want to run a full inspection clearing out any stored information, check the box for Cached Results and select Reset.

Similarly, if you want to reset warnings and suggestions that have been ignored, check the box for Ignored Results and select Reset. This will clear out ignored warnings and/or suggestions and once again include those employees in the next scan.